Every autumn the same thing happens: the heating goes on, the windows start to stream and mould appears in a corner. The way you heat a home changes how much condensation forms, sometimes more than people expect, and it costs nothing to check.

Quick answer

Condensation forms when warm, moist air meets a cold surface. Heating helps by keeping surfaces warmer, but short blasts of heat followed by long cold gaps do the opposite, because walls and glass stay cold while the air fills with moisture. Steady background warmth, ventilating at the right moments and keeping furniture off outside walls reduce it. A leak or a wall that is damp in mild weather is a different problem.

Check this first

  1. Measure before you change anything. Put a cheap hygrometer in the coldest bedroom and another in the living room, and note the readings in the morning and evening for a week. BRE describes temperature and humidity monitoring as the most effective way of diagnosing damp, because a single look can mislead. Readings that stay above about 60 to 65 percent are where mould and dust mites do well.
  2. Look at the pattern of heating, not just the thermostat. GOV.UK guidance says homes that are insufficiently insulated and heated are more prone to moisture build-up and condensation. A room heated hard for two hours and cold for twenty gives moisture a cold surface to land on all day. Where you can afford it, a lower, steadier temperature across the day often works better than a high setting for short periods.
  3. Heat the rooms that are used, and keep doors shut to the ones that are not. An unheated bedroom next to a warm living room collects the moisture that drifts through the house and condenses on its cold walls. Heat it gently if you can, and keep the door shut so humid air from elsewhere does not flow in.
  4. Ventilate when moisture is made, not all day. GOV.UK guidance suggests opening a window wide for a short time and closing it once the air has changed, or using the vent position, which holds the window partly open but locked. Do this after showering, cooking and drying anything damp, rather than leaving a window open all day and cooling the room.
  5. Leave trickle vents and air bricks open, and move furniture off outside walls. Replacement windows are required to have trickle vents, and blocking them traps moisture. GOV.UK guidance also recommends leaving a gap between furniture and external walls, so air can move and the wall behind can warm up.
  6. Cut the moisture at source. Run kitchen and bathroom fans that vent outside, keep lids on pans, shut the bathroom door while showering and avoid drying washing on radiators in a closed room. Our guides on drying laundry indoors and bathroom and kitchen extraction cover the detail.

What you find, and what to do

What you findLikely causeWhat to do
Wet windows and cold corners that clear when the home warms upCondensation, mostly habitsSteadier heat, short bursts of ventilation, wipe glass in the morning.
Humidity above 65 percent all day in every roomToo much moisture for the home to shedCheck extraction and laundry habits first. A dehumidifier may be worth considering after that.
Mould on one outside wall only, worse behind furnitureCold wall and still airPull furniture off the wall, clean the mould safely, then look at insulation and cold bridging.
Damp patch that appears after rain, not after cold nightsPenetrating dampCheck gutters, pointing and render. Not a dehumidifier job.
Damp band low on the wall, with salt marksPossible rising dampGet a Property Care Association member to diagnose. Not a dehumidifier job.

Winter is worse for three reasons that stack up. Windows stay shut, so humid air stays put. Surfaces are colder, so more of the moisture in the air lands on them. And more moisture is made indoors, because laundry gets dried inside and the kettle, hob and shower run more often. Heating helps with the second, ventilation with the first, and cutting what you produce with the third. No single habit does the whole job, which is why the table above matters: it separates the problems a change of routine can fix from the ones it cannot.

Whenever you clean mould, use a mould and mildew product in preference to bleach, wear a mask, gloves and goggles, and keep the room door shut so spores do not spread. GOV.UK guidance also says larger areas need a qualified professional. Cleaning treats the stain only, so the checklist above still needs doing.

In Canterbury and the villages around it. The city has a medieval centre, student housing and Victorian terraces, and heating habits differ widely between them. Old solid walls take a long time to warm, so steady low heat matters more there, while newer, tighter homes depend on ventilation to shed moisture. If you rent, ask your landlord before changing anything fixed. For a village example, see Harbledown, with its conservation area and Georgian terraces, Sturry, with riverside cottages and later estates, and Fordwich, a small riverside town by the Great Stour.
When a dehumidifier is not the answer. A dehumidifier cannot fix a leaking roof, a failed gutter, rain coming through a wall or damp rising from the ground, and it cannot make up for a home that is never heated. Rented homes are not suitable unless the landlord authorises the changes, and a home with no usable loft is not a candidate, because the unit is mounted there.

Where a Dryzen system fits. A Dryzen system is a loft-mounted dehumidifier with insulated ductwork to the central area or stairway of the home. Each unit covers up to 150 square metres, extracts about 12 litres a day and costs about 20 pounds a year to run. It has an activated carbon filter and a smart app is included. The warranty is 10 years on parts and labour and 1 year on the compressor. It needs a loft to mount the unit, and it is not suitable for a rented home unless the landlord authorises the changes. It suits condensation-type damp in an owner-occupied home with a loft. It helps stop the conditions mould and dust mites need but does not remove mould that is already there, so clean that first, and it does not repair leaks or rising damp.

Gold Pack membership (£199 per year) includes remote humidity monitoring of your home and your Dryzen unit and a yearly onsite system check: we monitor the humidity and the unit's performance and alert you if there are any issues.

Common questions

Is it better to leave the heating on low all day?

For many homes a lower, steadier temperature keeps walls and glass warmer than short bursts, which reduces condensation. The right pattern depends on your home and your budget, so use a hygrometer to see what your own readings do.

Should I open windows in winter?

Briefly, yes. A short, wide opening after showering, cooking or drying washing replaces humid air with drier air. Leaving a window open all day mostly wastes heat.

Will turning the heating up stop mould?

Not on its own. Warmer surfaces help, but if moisture keeps being made and has nowhere to go, condensation moves to the next cold spot. Heating, ventilation and moisture control work together.

Not sure what is causing yours?

Book a free survey and we will tell you honestly whether it is habits, the building or something else, even if that means we are not the right fix.

Book a Free Survey

Keep reading

Sources: GOV.UK, Understanding and addressing the health risks of damp and mould in the home; BRE, Diagnosing the causes of dampness in buildings.

Ready to Solve Your Home's Damp Problem?

Book your free, no-obligation survey today. Our specialist will assess your home and give you an honest recommendation.

Book Your Free Survey